Gm4e01 ((link))

| Parameter | Value | |-----------|-------| | | 2.7V – 5.5V (typical 5V) | | Supply Current (Icc) | 0.8 – 1.5 mA (low power) | | Carrier Frequency | 38 kHz (most common) – verify with datasheet | | Peak Wavelength | 940 nm | | Output Type | Active Low (signal = low, idle = high) | | Reach Distance | 8–15 meters (depending on IR LED power) | | Viewing Angle | ±45° to ±55° | | Operating Temp | -25°C to +85°C | | Pinout | 1: OUT, 2: GND, 3: Vcc (varies; check below) |

#include <IRremote.h>

| Pin | Name | Description | |-----|------|-------------| | 1 | OUT | Data output (to MCU) | | 2 | GND | Ground (0V) | | 3 | Vcc | +5V power supply | gm4e01

Don't just stretch the image. Use Ralf's Widescreen Gecko Codes to increase the actual field of view without distorting the karts. | Parameter | Value | |-----------|-------| | | 2

Use the "BBA" (Broadband Adapter) settings in Dolphin to play online with friends using services like XLink Kai . Pro Tip: The "Hidden" Debug Menus Pro Tip: The "Hidden" Debug Menus Note: If

Note: If this is not an IR receiver (e.g., if it’s on a power supply board), please check the marking context below. However, 99% of inquiries for GM4E01 point to the Sharp IR module.